Change the way you do pole change outs. The Splice Slicer removes H Taps and barrel sleeves from alunimun conductors. Simply use your impact to turn the threaded bearing into the connector until it reaches the conductor. The tap then peels off. Several cuts may be required on the taps up to 795 MCM. Remove the cutter after the first cut on the exterior of the tap and move across until the entire connector is cut. Eliminate the need to cut conductors and retension them while working them hot if a tap is in your way. Cobb EMC in Marietta, GA has seen a significant time reduction and major monetary savings by not using expensive automatic sleeves after purchsing the SUR-SpliceSlicer.

Features

• Save on labor and materials
• No interruptions to the line service
• Faster than manual labor